DAR File No. 37337

This rule was published in the March 1, 2013, issue (Vol. 2013, No. 5) of the Utah State Bulletin.


Environmental Quality, Solid and Hazardous Waste

Rule R315-316

Infectious Waste Requirements

Notice of Proposed Rule

(Amendment)

DAR File No.: 37337
Filed: 02/15/2013 08:50:54 AM

RULE ANALYSIS

Purpose of the rule or reason for the change:

Changes are required to conform with S.B. 21 passed during 2012 General Session (Chapter 360, Laws of Utah 2012).

Summary of the rule or change:

S.B. 21, passed during the 2012 General Session, removed some authorities from the Utah Solid and Hazardous Waste Control Board and its Executive Secretary and gave them to the Director of the Division of Solid and Hazardous Waste. This change in statute now requires changes to the Solid and Hazardous Waste rules. Specifically, references to the "Board" and the "Executive Secretary" in the rules need to be changed to "Director" as appropriate.

State statutory or constitutional authorization for this rule:

  • Section 19-6-108
  • Section 19-6-105
  • Section 19-6-107

Anticipated cost or savings to:

the state budget:

There are no anticipated costs or savings as this amendment only changes who has authority to make regulatory decisions.

local governments:

There are no anticipated costs or savings as this amendment only changes who has authority to make regulatory decisions.

small businesses:

There are no anticipated costs or savings as this amendment only changes who has authority to make regulatory decisions.

persons other than small businesses, businesses, or local governmental entities:

There are no anticipated costs or savings as this amendment only changes who has authority to make regulatory decisions.

Compliance costs for affected persons:

There are no compliance costs for affected persons as this amendment only changes who has authority to make regulatory decisions.

Comments by the department head on the fiscal impact the rule may have on businesses:

There is no anticipated fiscal impact on businesses as this amendment only changes who has authority to make regulatory decisions.

Amanda Smith, Executive Director

The full text of this rule may be inspected, during regular business hours, at the Division of Administrative Rules, or at:

Environmental Quality
Solid and Hazardous WasteRoom Second Floor
195 N 1950 W
SALT LAKE CITY, UT 84116-3097

Direct questions regarding this rule to:

  • Allan Moore at the above address, by phone at 801-536-0211, by FAX at 801-536-0222, or by Internet E-mail at allanmoore@utah.gov
  • Tina Mercer at the above address, by phone at 801-536-0259, by FAX at 801-536-0222, or by Internet E-mail at tmmercer@utah.gov

Interested persons may present their views on this rule by submitting written comments to the address above no later than 5:00 p.m. on:

04/01/2013

This rule may become effective on:

04/15/2013

Authorized by:

Scott Anderson, Director

RULE TEXT

R315. Environmental Quality, Solid and Hazardous Waste.

R315-316. Infectious Waste Requirements.

R315-316-4. Infectious Waste Transportation Requirements.

(1) Infectious waste shall not be transported in the same vehicle with other waste unless the infectious waste is contained in a separate, fully enclosed leak-proof container within the vehicle or unless all of the waste is to be treated as infectious waste in accordance with Rule R315-316.

(2) Persons manually loading or unloading containers of infectious waste onto or from transport vehicles shall:

(a) be trained in the proper use of protective equipment;

(b) have available and easily accessible at all times puncture resistant gloves and shoes, shatterproof glasses, and coveralls; and

(c) shall have face shields and respirators available.

(d) Protective gear that becomes soiled with infectious waste shall be decontaminated or disposed as infectious waste.

(3) Surfaces of transport vehicles that have contacted spilled or leaked infectious waste shall be decontaminated by procedures approved by the [Executive Secretary]Director.

(4) Vehicles transporting infectious waste shall meet all warning requirements of the Department of Transportation related to infectious, biohazardous or biomedical waste.

(5) Each truck, trailer, or semitrailer, or container used for transporting infectious waste shall be designed and constructed, and its contents limited, so that under conditions normally incident to transportation, there shall be no releases of infectious waste to the environment.

(6) Any truck, trailer, semitrailer, or container used for transporting infectious waste shall be free from leaks, and all discharge openings shall be securely closed during transportation.

(7) No person shall transport infectious waste into the state for treatment, storage, or disposal unless the waste is packaged, contained, labeled and transported in the manner required by this section.

(8) All transporter vehicles shall carry a spill containment and cleanup kit and the transport workers shall be trained in spill containment and cleanup procedures.

 

R315-316-5. Infectious Waste Treatment and Disposal Requirements.

(1) Infectious waste shall be treated or disposed as soon as possible and shall be treated or disposed at a facility with a permit or other form of approval allowing the facility to treat or dispose infectious waste.

(2)(a) All material that has been rendered non-infectious through an approved treatment method may be handled as non-infectious solid waste, provided it is not otherwise a hazardous waste or a radioactive waste excluded from disposal in a solid waste facility by Rules R315-301 through 320.

(b) Except for incineration and steam sterilization, no treatment method may be used to render materials non-infectious without receiving prior approval from the [Executive Secretary]Director.

(3) Infectious waste may be incinerated in an incinerator provided the incinerator is permitted or approved under Rules R315-301 through 320.

(4) Infectious waste may be sterilized by heating in a steam sterilizer to render the waste non-infectious.

(a) The operator shall have available, and shall certify in writing that he understands, written operating procedures for each steam sterilizer, including time, temperature, pressure, type of waste, type of container, closure of container, pattern of loading, water content, and maximum load quantity.

(b) Infectious waste shall be subjected to sufficient temperature, pressure and time to inactivate Bacillus stearothermophilus spores in the center of the waste load at a 6 Log 10 reduction or greater.

(c) Unless a steam sterilizer is equipped to continuously monitor and record temperature and pressure during the entire length of each sterilization cycle, each package of infectious waste to be sterilized shall have a temperature-sensitive tape or equivalent test material, such as chemical indicators, attached that will indicate if the sterilization temperature and pressure have been reached. Waste shall not be considered sterilized if the tape or equivalent indicator fails to indicate that a temperature of at least 250 degrees Fahrenheit (121 degrees Celsius) was reached and a pressure of at least 15 psi was maintained during the process.

(d) Each sterilization unit shall be evaluated for effectiveness with spores of B. stearothermophilus at least once each 40 hours of operation or each week, whichever is less frequent.

(e) A written log for each load shall be maintained for each sterilization unit which shall contain at a minimum:

(i) the time of day and the date of each load and the operator's name;

(ii) the amount and type of infectious waste placed in the sterilizer; and

(iii) the temperature, pressure, and duration of treatment.

(5)(a) Alternative treatment methods may be approved on a site-specific basis when the [Executive Secretary]Director finds the proposed alternative treatment method renders the material non-infectious.

(b) The determination shall be based on the results of laboratory tests, submitted by the person proposing the use of the treatment method, meeting the following requirements:

(i) the laboratory tests shall be conducted:

(A) by qualified laboratory personnel;

(B) using recognized microbial techniques;

(C) on samples that have been inoculated with the test organisms, then subjected to the proposed treatment method and processed in an identical way to the treatment process being proposed for approval; and

(ii) the results of the tests must document that the proposed treatment method inactivates:

(A) vegetative bacteria - Staphylococcus aureus (ATCC 6538) or Pseudomonas aeruginosa (ATCC 15442) at a 6 Log 10 reduction or greater (a 99.9999% reduction or greater of the organism population);

(B) fungi - Candida albicans (ATCC 18804), Penicillium chrysogenum (ATCC 24791), or Aspergillus niger at a 6 Log 10 reduction or greater;

(C) viruses - Polio 2, Polio 3, or MS-2 Bacteriophage (ATCC15597-B1) at a 6 Log 10 reduction or greater;

(D) parasites - Cryptosporidium spp. oocysts or Giardia spp. cysts at a 6 Log 10 reduction or greater;

(E) mycobacteria - Mycobacterium terrae or Mycobacterium phlei at a 6 Log 10 reduction or greater; and

(B) Bacterial spores - Bacillus stearothermophilus spores (ATCC 7953) or Bacillus subtilis spores (ATCC 19659) at a 4 Log 10 reduction or greater (a 99.99% reduction or greater of the organism population).

(iii) The [Executive Secretary]Director shall review the submitted materials and reply in writing within 30 days of the receipt of the treatment studies.

(6) Infectious waste may be discharged to a sewage treatment system that provides secondary treatment of waste but only if the waste is liquid or semi-solid and if approved by the operator of the sewage treatment system.

(7) Infectious waste may be disposed in a permitted Class I, II, or V Landfill. Upon entering the landfill, the transporter of infectious waste shall notify the landfill operator that the load contains infectious waste. The landfill operator shall abide by the following procedures in the disposition and covering of infectious waste:

(a) place the infectious waste containers in the working face with sufficient care to avoid breaking them;

(b) completely cover the infectious waste immediately with a minimum of 12 inches of earth or waste material containing no infectious waste; and

(c) not compact the infectious waste until completely covered with 12 inches of earth or waste material containing no infectious waste.

 

KEY: solid waste management, waste disposal

Date of Enactment or Last Substantive Amendment: [January 15, 2010]2013

Notice of Continuation: February 14, 2008

Authorizing, and Implemented or Interpreted Law: 19-6-105

 


Additional Information

The Portable Document Format (PDF) version of the Bulletin is the official version. The PDF version of this issue is available at https://rules.utah.gov/publicat/bull-pdf/2013/b20130301.pdf. The HTML edition of the Bulletin is a convenience copy. Any discrepancy between the PDF version and HTML version is resolved in favor of the PDF version.

Text to be deleted is struck through and surrounded by brackets (e.g., [example]). Text to be added is underlined (e.g., example).  Older browsers may not depict some or any of these attributes on the screen or when the document is printed.

For questions regarding the content or application of this rule, please contact Allan Moore at the above address, by phone at 801-536-0211, by FAX at 801-536-0222, or by Internet E-mail at allanmoore@utah.gov; Tina Mercer at the above address, by phone at 801-536-0259, by FAX at 801-536-0222, or by Internet E-mail at tmmercer@utah.gov.